Attaching Memory Unit Type C 256MB (SDRAM Module)
37
3
D Pull out the handle of the control-
ler board.
E Pull the handle, and then slide
the controller board out.
F Place the controller board on a flat
surface.
G The memory unit is installed in
the slot shown in the illustration
below.
H Remove the default memory unit
before installing a new memory
unit. Press down the levers on
both sides to remove the default
memory unit.
I Align the notch of the memory
unit to the slot, and then push it
down until it clicks.
J Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
ZKGX370E
ZKGX260E
ZKDX021J
AGN016S
ZKGX130E
ZKGX250E
KirP4GB_Setup-F4_FM_forPaper.book Page 37 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
