Attaching Bluetooth Interface Unit Type C
49
3
I Attach the Bluetooth interface
unit.
Insert the end of the Bluetooth in-
terface unit to the opening ( ), and
then push down until it clicks ( ).
J Fasten the network interface unit
to the controller board with the
two screws.
K With the side labeled INSERT fac-
ing up, slowly insert the card into
the interface unit, until it stops.
L Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
M Push back the handle of the con-
troller board until it clicks.
ZKGX420E
ZKGX431E
ZKGX442E
ZKGX070E
ZKGX601E
ZKGX380E
KirP4GB_Setup-F4_FM_forPaper.book Page 49 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
