Attaching Duplex Unit AD610
55
3
F Align the power cable to the left
side groove of the duplex unit,
and then slide the duplex unit in
until it is connected to the printer.
Note
❒ After finishing installation, you
can check the duplex unit is
properly installed: Print the
configuration page from the
“List/Test Print” menu. If the
new device is listed in the col-
umn of configuration options,
then it has been properly in-
stalled.
❒ If the duplex unit is not installed
properly, repeat the procedure
from the start. If you cannot in-
stall it properly even after rein-
stallation, contact your sales or
service representative.
❒ If the printing position is not
correct, adjust the registration of
the trays. For more information
about adjusting the registration
of the trays, see “Adjusting Tray
Registration”, Maintenance
Guide.
Reference
For printing the configuration
page, see p.28 “Test Printing”.
ZKGX231E
ZKGX240E
KirP4GB_Setup-F4_FM_forPaper.book Page 55 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
