Paper and Other Media Supported by This Printer
5
1
•
The size is supported and indicated on the tray dial. Be sure to set the pa-
per size dial to match the actual paper size loaded in the tray.
•
The size is supported but not indicated on the tray dial. You should set the
tray dial to “p”, and select the paper size with the control panel.
•
The size is supported but the paper size should be set with the control pan-
el. There is no dial on the tray.
See p.21 “Loading Paper in the Bypass Tray”
See p.26 “Loading Envelopes”
•
The size is supported, but it should be set as a custom size using the control
panel.
The supported size may differ depending on the printer language you use.
Set as a custom size setting using the control panel.
The following sizes are supported:
• Bypass Tray: approximately 90 - 305 mm in width, and 148 - 432 mm in
length.
• Paper Feed Unit (Tray 2/3): approximately 182 - 297 mm in width, and
160 - 432 mm in length.
•
The size is not supported.
KirP4GB_Mainte-F5_FM_forPaper.book Page 5 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
