Paper and Other Media Supported by This Printer
7
1
•
The size is supported and indicated on the tray dial. Be sure to set the pa-
per size dial to match the actual paper size loaded in the tray.
•
The size is supported but not indicated on the tray dial. You should set the
tray dial to “p”, and select the paper size with the control panel.
•
The size is supported but the paper size should be set with the control pan-
el. There is no dial on the tray.
See p.21 “Loading Paper in the Bypass Tray”
See p.26 “Loading Envelopes”
•
The size is supported, but it should be set as a custom size using the control
panel.
The supported size may differ depending on the printer language you use.
Set as a custom size setting using the control panel.
The following sizes are supported:
• Bypass Tray: approximately 3.54 - 12.01 inches in width, and 5.83 - 17.01
inches in length.
• Paper Feed Unit (Tray 2/3): approximately 7.17 - 11.69 inches in width,
and 6.3 - 17.01 inches in length.
•
The size is not supported.
KirP4GB_Mainte-F5_FM_forPaper.book Page 7 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
