Fax Features
112
4
C Specify an End Receiver using the Quick Dial keys or [], and then
press the {OK} key.
D Press the {OK} key.
Note
! Selecting [Same as Basic Settings] will result in the same setting made for
[Forwarding] under [Administrator Tools].
! Press the button on the right of the display to switch the destination be-
tween fax number, e-mail address, IP-Fax destination, and folder.
! Set folder destinations using [Address Book Management] under [System Set-
tings]. For details about registering folder destinations, see "Registering
Folders".
! When a folder is specified as the forward destination, you can set a file for-
mat for forwarding. See "Parameter Setting" (switch 21, bit 3).
! Deleting a destination specified as a forward destination from the destina-
tion list causes the settings of the forward destination to be deleted, so they
must be registered again. When a destination is changed, a document is
transmitted to the new destination. If there is no destination of the speci-
fied type, you can set which destination to be used as an alternative desti-
nation. See "Parameter Setting" (switch 32, bit 0).
Reference
p.96 “Parameter Setting”
p.190 “Registering Folders”
To Next Page
Loading...
