57
5. Remarks
Do's and Don'ts
CAUTION:
Important
r Do not turn the power off while
the On indicator is lit or blinking.
Doing so may damage the memo-
ry.
r Before unplugging the power cord
or turning off the main power
switch, make sure remaining mem-
ory space is at 100%, as shown on
the display. See p.13 “Turning Off
the Power” and “Turning Off the
Main Power”.
• When you use this machine for a
long time in a confined space with-
out good ventilation, you may de-
tect an odd smell. To keep the
workplace comfortable, we recom-
mend that you keep it well venti-
lated.
• Do not touch areas on or around
the fusing unit. These areas get hot.
• After making copies continuously,
the exposure glass may become
warm—this is not a malfunction.
• The area around the ventilation
hole might feel warm. This is
caused by exhaust air and is not a
malfunction.
• When the machine is not in use
and in stand-by mode, you may
hear a small noise inside. This is
caused by the image stabilization
process and is not a malfunction.
• Do not turn off the operation switch
while copying or printing. Make
sure all copying or printing has fin-
ished first.
• The machine might not produce
good copy images if condensation
forms inside as a result of rapid
temperature change.
• Do not open the covers of the ma-
chine while copying or printing. If
you do, misfeeds might occur.
• Do not move the machine during
copying or printing.
• If you operate the machine im-
properly or a machine failure oc-
curs, settings might be lost. Be sure
to make a note of your machine
settings.
• The manufacturer shall not be lia-
ble for any loss or damage result-
ing from mechanical failure, loss of
settings, or use of the machine.
• Unplug the power cord from the
wall outlet before you move the
machine. While moving the ma-
chine, you should take care that
the power cord will not be dam-
aged under the machine.
To Next Page
Loading...
