Copying
30
2
D Select [Paper Type] using {U} or {T}, and then press the {OK} key.
E Select [OHP (Transparency)] using {U} or {T}, and then press the {OK} key.
The “
Programmed” message appears.
F Select the paper size, if required.
G Place the originals, and then press the {Start} key.
H When the copy job is finished, press the {Clear Modes} key to clear the settings.
Note
❒ Printing on OHP transparencies is slower than printing on plain paper.
Reference
p.25 “Loading Paper on the Bypass Tray”
When Copying onto Thick Paper
When copying onto thick paper, select [Thick Paper] in Paper Type.
Important
❒ To prevent multiple sheets from being fed at once, fan paper before placing it
on the tray.
A Select [Bypass] using {U} or {T}.
B Load thick paper face down on the bypass tray.
C Press the {q} key.
To Next Page
Loading...
