Settings You Can Change with User Tools
55
4
Preset R/E Priority
You can set the ratio with priority
when [R/E] is selected.
Note
r Default:
•Metric version: 71%
• Inch version: 65%
Duplex Margin
You can specify left margin on the
back side of copies, and top margin
on the front side. Select [Top Margin] or
[Left Margin], and then set the required
value.
• Top Margin: 0 - 50 mm, 0” – 2”
• Left Margin: 0 - 50 mm, 0” – 2”
Limitation
r Available only for Type 2
Note
r Default:
•Metric version: 5 mm
• Inch version: 0.2 inch
Rotate Sort
You can select a Sort function: [On] or
[Off].
When you select [On], you can select
[Rotate Sort]. See p.32 “Sort”.
When you select [Off], you cannot se-
lect [Rotate Sort]. If you press the
{Sort} key, only Sort is enabled.
Note
r Default: Off
r When using Type 1 without the
optional tray, you cannot use this
setting.
Rotate Sort:Auto Continue
If you select [Off] when the paper tray
in use runs out of paper, the machine
stops, allowing you to add paper so
all copies can be rotate-sorted.
Note
r Default:Off
r When using Type 1 without the
optional tray, you cannot use this
setting.
Letterhead Setting
If you select [On] for this function, the
machine rotates the image correctly.
Note
r Default: Off
r Orientation-fixed (top to bottom)
or two-sided paper (Type 2 only)
might not print correctly, depend-
ing on how the originals and paper
are placed.
Reference
When using letterhead paper,
check its orientation is correct. See
p.46 “Orientation-Fixed Paper or
Two-Sided Paper”.
To Next Page
Loading...
