Registering Folders
195
7
Y Press the {User Tools/Counter} key.
Note
! For registration of a name, see "Registering Names".
! You can enter up to 128 characters for the user name.
! You can enter up to 64 characters for the password.
! If the connection test fails, check the settings, and then try again.
! When [Do not Specify] is selected in step
J
, the SMB User Name and SMB
Password that you have specified in Default User Name / Password
(Send) of File Transfer settings applies.
! If User Authentication is specified, contact your administrator.
Reference
p.140 “Registering Names”
p.195 “Locating the SMB folder manually”
p.196 “Locating the SMB folder using Browse Network”
p.53 “File Transfer”
"Entering Text", About This Machine
Locating the SMB folder manually
A Select [Manual Entry] using {U} or {T}, and then press the {OK} key.
B Enter the path and then press the {OK} key.
If the format of the entered path is not correct, a message appears. Press [Exit],
and then enter the path again.
Note
! Enter the path using this format: "\\ServerName\ShareName\PathName".
! You can also enter an IPv4 address.
! You can enter a path using up to 128 characters.
Reference
"Entering Text", About This Machine
To Next Page
Loading...
