Scan Settings
This section describes the user tools in the [Scan Settings] tab under [Scanner Features].
Default settings are shown in bold type.
A.C.S. Sensitivity Level
Sets the sensitivity level for judging colour/black and white for scanning originals when [Scan Type]
is set to [Auto Colour Select].
The default setting is the middle of 5 adjustment levels.
Wait Time for Next Orig.: Exposure Glass
To divide originals and scan them individually with the exposure glass to form a single file, select
[Continuous Wait], [Off], or [Set Wait Time] for the waiting status.
The default setting is Set Wait Time, 60 second(s).
If you select [SADF] in [Original Feed Type] on the Scan to Folder screen, the [Wait Time for Next
Orig.: Exposure Glass] setting becomes invalid.
If you select [Batch] in [Original Feed Type] on the Scan to Folder screen, the [Wait Time for Next
Orig.: Exposure Glass] setting becomes invalid, and the machine waits for an additional original to
be placed.
If [Set Wait Time] is selected, enter the wait time in seconds (3-999) for placing additional originals
with the number keys. Scanning will start if additional originals are placed and the [Start] key is pressed
within this time. You can end scanning and begin transmission by pressing the [ ] key within this time.
Once the specified time has elapsed, transmission starts automatically.
If [Continuous Wait] is selected, the machine will wait for additional originals until the [ ] key is
pressed. Scanning will start when additional originals are placed and the [Start] key is pressed. You
can end scanning and begin sending by pressing the [ ] key.
If originals are placed in the ADF, transmission will start without waiting for additional originals after
all originals in the ADF have been scanned, regardless of the specified settings.
If a paper misfeed occurs or any of the following operations are performed while the machine is
waiting for additional originals, the countdown stops and does not start again until the [ ] key is
pressed.
• Changing the settings such as the scan settings
• Opening the upper cover of the ADF
• Pressing the [Interrupt] key to activate the copy mode
Wait Time for Next Original(s): SADF
When dividing originals and scanning them separately with the ADF to form a single file, select [Set
Wait Time] or [Continuous Wait] for the waiting status.
The default setting is Set Wait Time, 60 second(s).
Scan Settings
185
To Next Page
Loading...
Need help?
General
