Category Item Setting
Device Settings/
Logs
Collect Access Logs Active
Security/User
Lockout Policy
Lockout Active
Security/User
Lockout Policy
Number of Attempts before
Lockout
5 times or less.
See "User Lockout Function".
Security/User
Lockout Policy
Lockout Release Timer Set to Active or Inactive. When setting to Active, set
the Lockout release timer to 60 minutes or more.
See "User Lockout Function".
Security/User
Lockout Policy
Lock Out User for When setting "Lockout Release Timer" to[ Active],
set the
Lockout release timer to 60 minutes or more.
See "User Lockout Function".
Network/
SNMPv3
SNMPv3 Function Inactive
To use
SNMPv3 functions, set "SNMPv3 Function"
to [Active], and set "Permit SNMPv3
Communication" to [Encryption Only]. Because
SNMPv3 enforces authentication for each packet,
Login log will be disabled as long as SNMPv3 is
active.
Security/Network
Security
FTP Inactive
Before specifying
this setting, set "Network Security
Level" to [Level 2] on the control panel.
Security S/MIME "Encryption Algorithm": 3DES-168 bit
You
must
register the user certificate in order to use
S/MIME.
Address Book/E-
mail
User Certificate You must register the user certificate in order to use
S/MIME.
• For details about specifying an encryption algorithm and registering a user certificate, see "Using S/
MIME to Protect Email Transmission".
Additional Information for Enhanced Security
233
To Next Page
Loading...
