The top page of Web Image Monitor appears.
3. Click [Login].
The machine administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [User Lockout Policy] under "Security".
The User Lockout Policy page appears.
5. Set "Lockout" to [Active].
6. In the drop down menu, select the number of login attempts to permit before applying
lockout.
7. After lockout, if you want to cancel lockout after a specified time elapses, set "Lockout
Release Timer" to [Active].
8. In the "Lock Out User for" field, enter the number of minutes until lockout is disabled.
9. Click [OK].
User Lockout Policy is set.
10. Click [Logout].
Canceling Password Lockout
This section explains how to cancel user password lockout. User password lockout is configured by the
user administrator.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The administrator or supervisor with unlocking privileges can log in.
Enter the login user name and login password.
4. Click [Address Book].
The Address Book page appears.
5. Select the locked out user's account.
6. Click [Change].
7. Set "Lockout" to [Inactive] under "Authentication Information".
8. Click [OK].
9. Click [Logout].
If User Authentication is Specified
85
To Next Page
Loading...
