29
3. Other Print Operations
Form Feed
Use the form feed function to continue printing when a paper size or paper type
error occurred.
This function can be performed using the control panel.
Important
❒ The tray cannot be changed if the following function is set:
•Cover Sheet
Performing Form Feed
Use the following procedure to perform form feed.
A While an error message is displayed on the control panel, press the
{Stop/Start} key.
B Press {U} or {T} to select the tray, and then press the {#Enter} key.
Printing begins on paper from the selected tray.
Note
❒ If you want to print after adding paper to the tray, load the correct paper,
and then press the {Stop/Start} key.
❒ If a tray with a smaller paper size is selected, the print job may be cut short,
or other problems may occur.
To Next Page
Loading...
