Host Interface Menu
59
5
Host Interface Menu Parameters
This section explains parameters that can be set on the Host Interface menu.
❖ USB Timeout
You can specify how many seconds the printer should wait before ending a
print job that is receiving via USB. If printing is frequently interrupted by data
from other ports, increase the timeout period.
Default: 60 seconds
• 15 seconds
• 60 seconds
• 300 seconds
❖ Network Timeout
You can specify how many seconds the printer should wait before ending a
print job that is receiving via Ethernet. If printing operation is frequently in-
terrupted by data from other ports, you can increase the timeout period.
Default: 60 seconds
• 15 seconds
• 60 seconds
• 300 seconds
❖ Network Setup
You can make network-related settings.
•DHCP
Select whether to set the IPv4 address automatically or manually.
Default: On
•On
•Off
Important
❒ After changing the setting, turn off the power of the printer briefly, and
then turn it on again.
• MAC Address
Check the MAC address.
• IP Address
Specify the IPv4 address.
When [DHCP] is set to [On], the IP address cannot be changed.
To change it, set [DHCP] to [Off].
Contact your network administrator for information about the network
configuration.
Default: 192.0.0.192
•Subnet Mask
Specify the subnet mask.
When [DHCP] is set to [On], the subnet mask cannot be changed.
To change it, set [DHCP] to [Off]. Contact your network administrator for in-
formation about the network configuration.
Default: 255.255.255.0
To Next Page
Loading...
