Loading Paper
45
5
Loading Paper
This describes how to load paper into the paper tray and bypass tray.
WARNING:
CAUTION:
Loading Paper in Tray 1
The following example explains the loading procedure for the standard paper
tray (Tray 1).
Important
❒ Make sure paper is not stacked above the limit mark inside the tray. Misfeeds
might occur.
❒ After loading paper in the tray, specify the paper type and size using the con-
trol panel.
❒ Do not mix different types of paper in the same paper tray.
❒ If the bypass tray is open, close it before pulling out Tray 1.
❒ Do not move the side paper guides forcefully. Doing so can damage the tray.
❒ Do not move the end paper guide forcefully. Doing so can damage the tray.
❒ When inserting the tray, make sure it is not slanted. Inserting it at a slant can
damage the printer.
❒ Curled paper may jam, straighten curled paper before loading.
A Lift and pull Tray 1 carefully, and then pull it out with both hands.
Place the tray on a flat surface.
• Do not put your hands inside the printer when the input tray is re-
moved. Some internal parts become hot and are a burn hazard.
• Do not pull out the paper tray forcefully. If you do, the tray might fall and
cause an injury.
ASI005S
To Next Page
Loading...
