Ethernet Configuration
29
4
Specifying an IP Address (No DHCP)
Use the following procedure to assign a specific IP address to the printer. This
procedure is only necessary if you want to use the printer on a network without
DHCP, or want to prevent the printer's IP address from changing.
Before beginning this procedure, make sure you have the IP address, subnet
mask, and gateway address that the printer will use.
A Press the {Menu} key.
B
Press the
{T}
or
{U}
key to display
[
Host Interface
]
, and then press the
{
#Enter
}
key.
C
Press the
{T}
or
{U}
key to display
[
Network Setup
]
, and then press the
{
#Enter
}
key.
D Press the {T} or {U} key to display [DHCP], and then press the {#Enter} key.
E Press the {T} or {U} key to select [Off], and then press the {#Enter} key.
The address detected by the printer will appear.
ASI066S
Menu:
Host Interface
Host Interface:
Network Setup
Network Setup:
DHCP
DHCP:
Off
To Next Page
Loading...
