Making Printer Settings Using the Control Panel
60
5
• Gateway Address
Specify the gateway address.
When [DHCP] is set to [On], the gateway address cannot be changed.
To change it, set [DHCP] to [Off].
Contact your network administrator for information about the network
configuration.
Default: 192.0.0.192
•Frame Type (NW)
Default: Auto Select
•Auto Select
•Ethernet ll
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
• Active Protocol
Select active protocols.
•TCP/IP
Default: Active
Active, Not Active
•NetWare
Default: Active
Active, Not Active
•AppleTalk
Default: Active
Active, Not Active
• Ethernet Speed
Select the network speed to operate the printer.
Default: Auto Select
•Auto Select
• 10Mbps Half D.
• 10Mbps Full D.
• 100Mbps Half D.
• 100Mbps Full D.
❖ USB Speed
You can make setting for USB Host interface.
Default: Auto Select
• Full Speed
•Auto Select
Important
❒ After changing the setting, turn off the power of the printer briefly, and
then turn it on again.
To Next Page
Loading...
