• This function is displayed only on Type 1 models that have no hard disk installed.
• For details about the optional SDRAM module, see Hardware Guide.
Auto E-mail Notify
Specify whether or not to send an error message to a preset e-mail address when an error occurs in
the printer.
• After changing the setting, turn off the power of the printer briefly, and then turn it on again.
Default: [On]
• On
• Off
• For information, see Web Image Monitor Help.
Changing the System Menu
Follow the procedure below to change the settings for Energy Saver Timer.
1. Press the [Menu] key.
The menu screen appears.
2. Press the [ ] or [ ] key to select [System], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Auto Off], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Auto Off Timer], and then enter the [OK] key.
5. Press the [ ] or [ ] key to select the lead time needed to switch to auto off mode.
6. Press the [OK] key.
Wait for one second. The Auto Off appears.
5. Making Printer Settings Using the Control Panel
128
To Next Page
Loading...
