• Bypass Tray
Default: [Off]
• On
• Off
• When using custom size paper, if automatic tray selection is enabled, the size selected on the
control panel has priority. If this setting is disabled, the size selected from the printer driver has
priority.
• Only installed trays appear on the display panel.
• You can select multiple trays.
• If you need to have a tray locked, you must select the tray using both printer driver and control
panel.
Tray Priority
You can set a tray to be checked first when automatic tray selection is enabled from the printer driver.
The tray selected here is used when no tray is selected for a print job.
Default: [Tray 1]
• Only installed trays appear on the display panel.
• It is recommended that you load paper of the size and orientation you use most frequently in the
tray selected in this setting.
Changing the Paper Input Menu
Automatic tray selection
Follow the procedure below to change the automatic tray selection setting.
Paper Input Menu
107
To Next Page
Loading...
