SERVICE PROGRAM MODE TABLES
B064 Series/B140 Series/G126 5-32 SM
1112 Auto Process Control
Sets the temperature of the hot roller for auto process control to start.
[70
ο
~150
ο
/1
ο
C] DFU
1901* CPM Down for Special Paper
Selects the speed (copies per minute) for copying on thick paper or tab sheets. A
slower speed makes fusing better. This setting has no effect on fusing
temperature.
001 Thick Paper [0~4/1 step]
0: 25 cpm
1: 35 cpm
2: 40 cpm
3: 45 cpm
002 Tab Sheet [0~4/1 step]
0: 25 cpm
1: 35 cpm
2: 40 cpm
3: 45 cpm
1902* Fusing Web Motor Control
001 Fusing Web Used Area Display/Setting
Displays the percentage of the web consumption in 1% steps (0% ~ 100%). This
setting must be reset to zero after the web is replaced.
[0~120/1 %]
002 Fusing Web Motor Operation Interval
Adjusts the interval of copy operation time (seconds) after which the web motor is
driven.
[5~50/1 s]
003 Fusing Web Motor Operation Time
Adjusts the length of time that the web motor is driven.
[1~40/0.1 s]
004 Web Near End Value
Adjusts the timing of the web near end alert by changing the amount of web that
has been used before the alert is triggered.
[0~100/1 %]
005 Web Roll Coefficient
Determines the coefficient of the web take-up time from cleaning toner from the
roller while taking into consideration the take-up time for web buckle. DFU
[10~20/1]
To Next Page
Loading...
