SERVICE PROGRAM MODE TABLES
SM 5-33 B064 Series/B140 Series/G126
Service
Tables
1903* Web Job End
001 Yes/No
This determines whether the web motor is driven at the end of a job.
[0~1/1]
0: Off
1: On
Enable when too much paper dust is causing copies to blacken.
002 Job End Condition (Continuous PPC Time)
At the end of a job, the web motor is driven if the job lasted longer than the value of
this SP mode. Only valid if SP1903-001 is set to ‘On’.
[1~99/1s]
003 Job End Frequency
If the web motor is driven at the end of a job, this SP determines how many times
the web motor operation is executed.
[1~5/1]
1904 By-pass Tray Paper Size Correction
001 Minimum Size
Calibrates the minimum paper width position of the sensor (100 mm). Move the
side fences to the 100 mm position then press Execute.
002 Maximum Size
Calibrates the maximum paper width position of the sensor (A3). Move the side
fences to the A3 position then press Execute.
1905* Thick Paper – By-pass Tray
Adjusts the by-pass feed clutch operation for thick paper.
[0~1/1]
1: On: 30 ms
0: Off:
This setting switches the by-pass feed clutch on for 30 ms when the registration
motor turns on. It only happens when thick paper is selected, to help this paper
pass through the registration rollers.
1906 Temperature/Humidity Sensor DFU
001 Temperature Sensor
002 Humidity Sensor
1907 Pre-Fusing Idling On/Off (B140 only)
Pre-fusing idling: The hot roller turns freely to increase its temperature before thick
paper or OHP goes through the fusing unit.
[0~1/1]
0: Pre-fusing idling is not done.
1: The fusing motor turns the hot roller with no paper in the fusing unit. This
makes sure that the hot roller gets to the correct temperature. It is only done
for thick paper or OHP. In this mode, the paper stops at the registration roller.
This roller starts when the hot roller gets to the correct temperature.
To Next Page
Loading...
