Installing Options
93
G With the side labeled INSERT on the right, slowly insert the card into the
Bluetooth interface unit, until it stops.
H Press the antenna to extend it.
I Attach the antenna cap to the card.
❒ Be sure to return the provided screwdriver to its original position on the in-
side of the front cover.
❒ After finishing installation, check the Bluetooth interface unit is installed
properly: print the configuration page from the “List/Test Print” menu. If it is
installed properly, you will see “Bluetooth” for “Device Connection”.
❒ If the Bluetooth interface unit is not installed properly, reinstall it from the
start of the procedure. If you cannot install it properly even after attempting
reinstallation, contact your sales or service representative.
For details about printing the configuration page, see p.46 “Test Printing”.
To Next Page
Loading...
Need help?
General
