Ricoh CX1 - Page 217

215
10
Appendices
The flash does not fire or
the flash cannot charge.
The flash cannot be used in the
following cases:
• In bracket shoting
• In continuous mode
• In movie mode
In some scene modes, the flash is
disabled by default.
To shoot with the flash, change
the settings or mode.
P.43
P.107
P.103
P.85
P.90
The flash is set to flash off. Cancel Flash Off. P.43
Battery is running low. Charge the rechargeable battery. P.27
Even though the flash
fired, the picture is dark.
The distance to the subject
exceeds the flash range.
Get closer to your subject and
shoot. Change the flash mode or
the ISO setting.
P.43
P.124
The subject is dark. Correct the exposure. (Exposure
compensation also changes the
light intensity of the flash.)
P.120
The light intensity of the flash is not
appropriate.
Adjust the light intensity of the
flash.
P.106
The image is too bright. The light intensity of the flash is not
appropriate.
Adjust the light intensity of the
flash. Alternatively, move a little
away from the subject or
illuminate the subject with
another light source instead of
using the flash.
P.43
P.106
Subject is overexposed.
(The [!AE] symbol appears.)
Correct the exposure.
Cancel exposure time.
P.120
P.112
The brightness of the picture
display is not appropriate.
Adjust the brightness of the
picture display.
P.165
The image is too dark. The shot was taken in a dark place
while set to flash off.
Cancel Flash Off. P.43
The subject is underexposed. Correct the exposure.
Set to long exposure time.
P.118
P.112
The brightness of the picture
display is not appropriate.
Adjust the brightness of the
picture display.
P.165
The image lacks natural
color.
The picture was shot in conditions
that made it difficult for auto white
balance to adjust the white
balance.
Add a white object to the
composition or use a white
balance setting other than auto.
P.122
The date or recording
information does not
appear on the screen.
The screen display function is set
to no display.
Press the DISP. button to change
the display.
P.56
The brightness of the
picture display changes
during AF.
You are using AF in a dark place or
when the auto focus range and
surrounding brightness are
different.
This is normal. -
Problem Cause Solution Refer to