Printing Functions
55
3
Storing Stack Memory Mode Settings
Limitation
❒ To use Stack Memory mode, you
need to first set Memory Mode to
“Stack” using the user tools. See
“Memory Mode Setting” on p.113
“5 Mode Settings”.
A Press the {User Tools} key.
B Use the {U}{T}keys to select 4 In-
itial Settings, and then press the
{OK} key.
C Use the {U}{T} keys to select 7
Program/Change memory, and
then press the {OK} key.
D Use the {U}{T} keys to select a
number, and then press the {OK}
key.
Note
❒ If the number is already in use,
a message will be displayed
asking if you wish to overwrite
the settings stored. To over-
write, press the {OK} key. Oth-
erwise press the {Escape} key to
return to the previous display,
and then select another number.
E With the number keys, enter the
number of prints for each class,
and then press the {q} key.
Note
❒ Repeat Steps
D
and
E
to register
all of your classes.
F Press the {OK} key.
G Press the {Clear Modes/Energy Sav-
er} key.
The contents that you have stored
are now effective.
ANT027S
To Next Page
Loading...
