Settings You Can Change with User Tools
29
3
v Energy Saver Timer
The machine automatically enters Low Power mode automatically after a job
is finished, and the selected time elapsed.
Note
r Default: 1 min.
r The time can be set from 1 to 240 minutes, using the number keys.
r Energy Saver may not work when error messages appear.
r The machine automatically prints any printer data received while in Ener-
gy Saver mode.
v System Auto Reset Timer
The System Reset setting automatically switches the screen to that of the func-
tion set in Function Priority when no operations are in progress, or when an
interrupted job is cleared. This setting determines the system reset interval.
See p.25 “Function Priority”.
Note
r Default: On, 60 sec.
r The time can be set from 10 to 999 seconds in 1 second increments, using
the number keys.
r When the set time has passed, the control panel returns to the menu that
was displayed before the {User Tools/Counter} key was pressed.
v Copier Auto Reset Timer
Specify the time to elapse before copier modes reset.
Note
r If [Off] is selected, the machine does not automatically switch to the user
code entry screen.
r Default: On, 60 sec.
r The time can be set from 10 to 999 seconds, using the number keys.
To Next Page
Loading...
