Placing Originals
21
1
Placing custom size originals
When placing custom size originals in
the ADF, or ARDF, specify the size of
the originals.
Note
r Paper that has a vertical length of
105–297 mm (4.2"–11.6") and a hor-
izontal length of 128–1260 mm
(5.1"–49.6") can be placed with this
function.
A Select the paper tray using {U} or
{T}, and then press the {#} key.
B Select [Custom Size] using {U}or
{T}key, and then press the {OK}
key.
Note
r When [Auto Detect] is selected,
the size of the placed original
will be detected automatically.
C Enter the horizontal size of the
original using the number keys,
and then press the {OK} key.
Note
r If you make a mistake, press the
{Clear/Stop} key, and then enter
the value again.
D Enter the vertical size of the origi-
nal using the number keys, and
then press the {OK} key.
The “
Programmed” message ap-
pears with your set original size.
When the custom size originals
settings are registered,
appears on the top of copy display.
Note
r To cancel the size you have set,
press the {Clear Modes} key.
To Next Page
Loading...
