Ricoh M199 - Page 120

Service Menu
SM 4-5 M199/M200/M203/M204
System
Maintenance
Reference
Horiz Bypass
Tray
Adjusts the horizontal registration for the bypass
tray. If the machine settings are reset to the factory
defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert Bypass
Tray
Adjusts the vertical registration for the bypass tray.
If the machine settings are reset to the factory
defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Horiz.Dup Back
Adjusts the horizontal registration for the back side
in duplex mode. If the machine settings are reset
to the factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Vert.Dup Back
Adjusts the vertical registration for the back side in
duplex mode. If the machine settings are reset to
the factory defaults, this value does not change.
[-15 to 15 / 0 (Default) / 1 mm/step]
Init Engine
EEPROM
This clears all counters except "Full Color" and "Black and White" in
the total counter.
When you execute "Init Engine EEPROM", the engine EEPROM is
initialized.
Turn the machine power off/on after you change this setting.
Model
DFU (Designed for Factory Use)
Do not change this setting.
Displays only
Displays the current model in a dropdown list.
Brand ID
DFU (Designed for Factory Use)
Do not change this setting.
00* – 7F
Displays the current brand ID number.
Maintenance ID
DFU (Designed for Factory Use)
Do not change this setting.
00* – 7F
Displays the current maintenance ID number.