Push it firmly into the printer using the handle. The printer may malfunction if the controller board is
not properly installed.
8. Fasten the controller board to the printer using the two screws.
9. Plug in the power cord, and then turn on the printer.
10. Print the configuration page to confirm that the SDRAM module was installed correctly.
• Confirm that the SDRAM module was correctly installed by printing the configuration page. Check
that the total memory value is shown in "Device Connection" on the configuration page.
• The table below shows the total SDRAM module capacities.
Standard Extended Total
256MB 128MB 384MB
256MB 256MB 512MB
• If the SDRAM module was not installed properly, repeat the procedure from the beginning. If it cannot
be installed correctly even after reattempting installation, contact your sales or service representative.
• For information on printing the configuration page, see "Test Printing", Quick Installation Guide.
2. Installing Options
32
To Next Page
Loading...
Need help?
General
