Ricoh MP 7503 Series User Manual

About how to use the application's screen, see page 46 "[Fax] Screen".
When Using the Fax (Classic) Application
For details about how to use the classic fax function, see page 101 "Procedure for canceling a
transmission while the original is being scanned (classic)".
Procedure for canceling a transmission while the original is being scanned (classic)
1. Press [Stop].
2. Press [Cancel Scanning] or [Cancel TX].
Depending on the transmission mode and function you use, either [Cancel Scanning] or [Cancel
TX] is displayed.
Canceling a Transmission After the Original Is Scanned
Use this procedure to cancel a transmission after the original is scanned.
You can cancel transmission of a file while the file is being sent, stored in memory, or if it fails to transmit.
All the scanned data is deleted from memory.
When Using the Fax Application
About how to use the application's screen, see page 46 "[Fax] Screen".
When Using the Fax (Classic) Application
For details about how to use the classic fax function, see page 101 "Procedure for canceling a
transmission after the original is scanned (classic)".
Procedure for canceling a transmission after the original is scanned (classic)
1. Press [Stop].
You can also press [TX/RX Status / Print], and then [Check / Stop Transmission File].
2. If a confirmation message appears, press [Standby File List].
Canceling a Transmission
101

Ricoh MP 7503 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Hard Disk Drive	320 GB (Optional)
Power Source	220-240V, 50/60Hz
Print Speed	75 ppm
Paper Capacity	Maximum: 8, 300 sheets
Connectivity	USB, Ethernet, Wi-Fi
Supported Paper Sizes	A3, A4, A5, B4, B5
First Print Speed	2.9 seconds
Memory (RAM)	2 GB
Supported Media Types	Plain paper, Recycled paper, Thick paper, Thin paper, Envelopes
Monthly Duty Cycle	300, 000 pages