Ricoh MP 7503 Series User Manual

Placing Originals
Placing Originals on the Exposure Glass
• Keep your hands away from the hinges and exposure glass when lowering the ADF. Not doing
so may result in an injury if your hands or fingers are pinched.
• Do not lift the ADF forcefully. Otherwise, the cover of the ADF might open or be damaged.
1. Lift the ADF.
Be sure to lift the ADF by more than 30 degrees. Otherwise, the size of the original might not be
detected correctly.
2. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
Start with the first page to be scanned.
1
1
DPZ017
1. Positioning mark
3. Lower the ADF.
Placing Originals in the Auto Document Feeder
Be sure not to block the sensor or load the original untidily. Doing so may cause the machine to detect
the size of the original incorrectly or display a paper misfeed message. Also, be sure not to place
originals or other objects on the top cover. Doing so may cause a malfunction.
Placing Originals
69

Ricoh MP 7503 Series Specifications

General

Print Resolution	1200 x 1200 dpi
Duplex Printing	Standard
Hard Disk Drive	320 GB (Optional)
Power Source	220-240V, 50/60Hz
Print Speed	75 ppm
Paper Capacity	Maximum: 8, 300 sheets
Connectivity	USB, Ethernet, Wi-Fi
Supported Paper Sizes	A3, A4, A5, B4, B5
First Print Speed	2.9 seconds
Memory (RAM)	2 GB
Supported Media Types	Plain paper, Recycled paper, Thick paper, Thin paper, Envelopes
Monthly Duty Cycle	300, 000 pages