1. Press the [Home] key on the top left of the control panel, and press the [Document Server]
icon on the [Home] screen.
2. Press [To Scanning Screen].
3. Press [User Name].
4. Specify a user name, and then press [OK].
The user names shown are names that were registered in the Address Book. To specify a name not
shown in the screen, press [Manual Entry], and then enter a user name.
5. Press [File Name].
6. Enter a file name, and then press [OK].
7. Press [Password].
8. Enter a password with the number keys, and then press [OK].
You can use four to eight digits for the password.
9. For double-check, enter the password again, and then press [OK].
10. Specify the original scanning conditions.
11. Place the original.
The original feeds into the machine automatically.
If [Press Start Key] is selected for [Feed Start Method], scanning starts when you press the [Start]
key.
The original is scanned.
12. Press [Finish Scanning] after all documents are scanned.
The document is saved in the Document Server.
6. Document Server
98
To Next Page
Loading...
Need help?
General