8. Adding Paper and Ink
This chapter explains how to load paper. It also describes recommended paper sizes and types, and
precautions for adding ink and replacing the ink collector unit.
Precautions for Loading Paper
• Be careful when replacing the paper, clearing paper jams, or cleaning the platen. Follow the
instructions for these procedures properly. Not doing so could result in injury from the paper
cutter inside.
• When loading paper, take care not to trap or injure your fingers.
• When lifting up or lowering the paper input location cover, be careful not to trap or injure your
fingers.
• When opening or closing the front cover, do not put your fingers over the folding parts of the
covers. Doing so may result in your fingers becoming trapped or injured.
• Hold the paper roll horizontally with both hands. When the paper roll is attached to the paper
holder and if you hold the paper roll vertically, the paper roll may fall off and an injury may
result.
• When replacing paper rolls, do not touch the spool near the gear. Doing so may cause your
hands to get dirty. If your hands get dirty, wash the affected area thoroughly with soap and
water.
• You cannot load paper in the following situations:
• When printing
• During maintenance or other operations
• When covers are open
103
To Next Page
Loading...
