Ricoh PE-P1 - Page 121

Group (Tab) Item Selections Remarks
FW Update
button
FW update
button
This button is for updating the controller firmware.
The button for updating the engine firmware is
located in the "SP Mode 1" tab.
"*" indicates the factory default value.
System
Item Selections Remarks
Auto Continue On/Off *
Copies 1*-999
PCL only. Default is 1. Always disabled in the
GDI model.
Sub Paper Size Off */ Auto PCL. A4 Letter override
2 Sided Print
Off */ Short Edge Bind/ Long
Edge Bind
PCL only
Blank Page Print Print */ Not Print
"Manual Duplex/Cover" has higher priority
than the "Blank Pages" setting.
Low Power Standby
On
5. Service Tables
120
5