Ricoh PE-P1 - ID Chip Board

2. Rear cover (* Rear Cover)
3. Left cover (* Left Cover)
4. LSU fan motor [A] (hooks,  x 1)
• Install the LSU fan motor with its decal facing the outside of the machine.
ID Chip Board
1. Operation panel (* Operation Panel)
2. Rear cover (* Rear Cover)
3. Left cover (* Left Cover)
4. Controller box cover (printer model: * Controller Board) or controller bracket (MF model: *
Controller Board)
5. Disconnect the connector (CN305) on the EGB.
6. Interlock switch base (* Interlock Switches)
7. Fusing fan base (* Fusing Fan Motor)
8. Drive unit (* Black AIO Motor)
3. Replacement and Adjustment
68
3