Ricoh PE-P1 - ITB (Image Transfer Belt) Cleaning Unit

After replacing the image transfer belt unit
• Do the following step 2 with the front cover of the machine open.
1. Open the front cover and turn on the machine.
2. Execute "Reset Transfer Unit Life Counter" with the "SP Mode 2" tab (printer model) or the "Engine
Maintenance" menu (MF model).
3. Close the front cover.
4. Execute "Trans. Belt Adjust" with the "SP Mode 2" tab (printer model) or the "Engine Maintenance"
menu (MF model).
5. Adjust the registration settings for each tray and for the front and rear sides of the paper with the "SP
Mode 2" tab (printer model) or the "Engine Maintenance" menu (MF model) if necessary.
ITB (Image Transfer Belt) Cleaning Unit
• The ITB cleaning unit contains waste toner. When removing the ITB cleaning unit, put it on a sheet of
paper.
1. Image transfer belt unit (* Image Transfer Belt Unit)
2. Left handle [A] (hook, bushing x 1)
3. Right handle [B] (hook, bushing x 1)
Image Transfer
35
3