Symbol Rate
This setting limits the transmission speed range in V.34 mode
by masking the desired symbol rate(s).
[Not Used (Default)/ 3429 Sym/Sec
/ 3200 Sym/Sec/ 3000 Sym/Sec
/ 2800 Sym/Sec/ 2400 Sym/Sec]
Reseller Default
Not Execute Does not reset anything. Returns to the upper level.
Execute
Resets all the settings to the factory defaults except the following.
• Counter for Machine Life
After executing, the initial setup menu starts after the next power-on.
• The "Reseller Default" menu can be entered directly at power-on. If you want to enter this mode
directly, try the following procedure.
• Turn on the machine while pressing the "Copy" key.
Fax Service Test Menu
Entering the Fax Service Test Menu
Turn on the machine while pressing the "Fax" key.
Selecting an Item
To select the item, press the "Up" or "Down" key.
Going into the Next Level/ Returning to the Previous Level
• To go into the next level of an item, select an item then press the "OK" key.
• To return to the previous level of an item, press the "Return" key.
Exiting the Maintenance Mode Menu
To exit the maintenance mode menu, press the "Clear/Stop" or "Return" key until the "Ready" display
appears.
Service Menu (MF Model)
149
To Next Page
Loading...
