After the line is connected via the external telephone, the
machine can detect silence (no tone) for the time length
specified by this setting.
[30 sec (Default)]
CNG Tone
Detection Time
CNG tone detection time ( RX mode : FAX / TEL, FAX / TAD
Only)
After the line is connected via the external telephone, the
machine can detect a CNG signal for the time length
specified by this setting.
[5 Sec (Default)/ 10 Sec]
CNG Cycles
Number of CNG cycles to be detected
This setting is only effective for FAX/TAD mode.
[1.5 Cycle (Default)/ 2.0 Cycle]
Tone Sound
Monitoring
Determines the period when tones from the line are
monitored.
[No Monitoring/ Up To Phase B (Default)/ All TX Phases]
Stop/Clear key
Pressing the Stop/Clear key can stop the current receiving
operation. Received data is lost.
[Not Functional (Default)/ Functional]
Off-Hook Level
Sets the off-hook detection threshold.
[10V (Default)/ 15V/ 20V/ 25V]
TX Settings
Redial Interval
Sets the redial interval when Tx fails.
[5 Min/ 6 Min]
Redialings
Sets the number of redials when Tx fails.
[2 times/ 3 Times/ 4 Times/ 5 Times]
Overseas Comm
Mode Settings
Overseas Comm
Mode
This sets the machine to ignore a DIS signal sent from the
called station once in a sending operation.
[Off (Default)/ Ignore DIS Once]
Minimum Time
Length
If this setting is set to "On", the machine detects the CNG
signal after the line is connected. If it is set to "Off", the
machine detects the CNG signal as long as the line is
connected.
[100 Ms/ 200 Ms/ 300 Ms/ 400 Ms (Default)]
5. Service Tables
146
To Next Page
Loading...
