This is the temperature to wait for a print job [b].
• [C]: Target temperature after 1st print (This depends on the target temperature of each paper type;
see the table below)
The machine keeps this temperature for printing (c) after the 1st print time (d: 14 seconds).
• [D]: First print temperature (target temperature + 10°C)
The machine keeps this temperature for the first printing time (d: 14 seconds).
• [E]: 10 seconds recovery temperature (155°C)
This is the low power mode for printing. This temperature is lower than the target temperature [C] and
saves power. This mode is adjustable (default: 15 minutes) with the "Power Saver" setting in the user
mode.
• [F]: Sleep mode
The machine turns off power to the engine unit for sleep mode after the machine has not got a print
job for 15 minutes.
Target Temperature for Each Paper Type
Paper Type Target Temperature
Thin 175°C
Plain 1 180°C
Recycled 180°C
Plain and Recycled 180°C
Plain 2 175°C
Thick 1 175°C
Cardstock 175°C
Bond 175°C
Envelopes 170°C
Fusing unit related SC codes
If one of the fusing unit components (such as thermistors, thermostat, fusing lamp etc.) is defective, the
following SC codes may be issued. For details, refer to the SC code list in the chapter "Troubleshooting".
• SC541, 542, 543, 544, and 545
If one of these SC codes is issued, click or press "Fuser SC Reset" with SOM (printer model) or "Engine
Maintenance" (MF model).
6. Detailed Section Descriptions
198
To Next Page
Loading...
