• Specify the size of tab stock under Paper Size in Tray Paper Settings. The sizes that can be used are
A4, 8
1
/
2
× 11, and 8
1
/
2
× 14.
• Tab stock can be loaded in tray 2 to 4, the Wide LCT, and the multi bypass tray (tray 7).
• Load tab stock copy side down in tray 2.
• Load tab stock copy side up in tray 3, tray 4, the Wide LCT, or the multi bypass tray (tray 7).
• When loading tab stock in tray 2, always use the tab sheet holder.
• Load tab stock so that it will be fed from the side without the tab first.
• When loading tab stock in tray 2, adjust the end fence position so that the tab sheet holder will fit the
tab stock.
• The Duplex function cannot be performed on tab stock. If [1 Sided 2 Sided] is selected, cancel the
setting.
Tab stock is fed starting from the top tab.
• In tray 2
Basic Procedure
55
To Next Page
Loading...
