4. Enter the length of [X1] with the number keys, and then press [ ].
5. Enter the length of [Y1] with the number keys, and then press [ ].
6. Enter the length of [X2] with the number keys, and then press [ ].
7. Enter the length of [Y2] with the number keys, and then press [ ].
If you want to erase the image on the back side of the original, press [2 Sided Setting] and then [Back].
Erasing the image on the back side is valid when you copy 2-Sided originals.
8. Press [OK].
9. To specify multiple areas, select areas 1 to 5, and then repeat steps 4 to 8.
10. Press [OK].
• To change the value you entered, press the key you want to change, and then enter a new value.
• You can specify up to five areas.
Erase Outside
Use this function to copy the original while erasing outside of a specified area.
4. Advanced Copying
194
To Next Page
Loading...
