3. Attach the tab fence to the end fence.
1. Tab fence
2. End fence
4. Set the end fence.
5. Press the elevator switch on the multi bypass tray (tray 7).
6. Select the multi bypass tray (tray 7) on the control panel.
7. Press the [ ] key.
8. Press [Tab Stock] under Special Paper.
9. Specify the shift value using [ ] or [ ] under Tab Position Shift.
10. Select the paper size.
11. Press [OK] twice.
12. Place originals, and then press the [Start] key.
• For details about how to load tab stock in paper trays, see “Copying onto Tab Stock”.
• Load tab stock so that it will be fed from the side without the tab first.
• p.54 "Copying onto Tab Stock"
2. Basic Copying
66
To Next Page
Loading...
