Ricoh R10 - Changing the Operation Sound Setting (Operation Sounds)

166
Changing Camera Settings
5
The following five operation sounds are made during camera
operation.
Note ----------------------------------------------------------------------------------------------
If you try to perform an operation that cannot be performed, the beep sound is emitted
regardless of the [Operation Sounds] setting.
1 Display the setup menu.
• For the operating procedure, see P.154.
2 Press the ADJ./OK button " to select [Operation
Sounds] and press the button $.
3 Press the button !" to select
the desired setting.
4 Press the ADJ./OK button.
Changing the Operation Sound
Setting (Operation Sounds)
Start sound : Sound when the camera is turned on.
Shutter release sound : Sound when the shutter release button is pressed.
Focus sound : Sound when the shutter release button is half-pressed and the
camera focuses on the subject.
Beep sound : Error sound indicating an operation that cannot be performed.
LevelSound : When [Level Setting] is set to [Sound] or [Disp + Snd]
(GP.172), the sound is continually emitted at a set interval
when the camera is level in shooting mode.
Available Settings Description
All *Default setting All sounds on
LevelSound Only the level sound is emitted.
Shutter Only the shutter sound and level sound are emitted.