Ricoh R10 - Changing Image Confirmation Time (LCD Confirm.)

168
Changing Camera Settings
5
Immediately after you press the shutter release button, the still
image taken is displayed on the screen for a moment so you can
check it. By default, the image confirmation time is set to 0.5
second, but this can be changed.
1 Display the setup menu.
• For the operating procedure, see P.154.
2 Press the ADJ./OK button " to select [LCD Confirm.]
and press the button $.
3 Press the button !" to select
the desired setting.
4 Press the ADJ./OK button.
Note ----------------------------------------------------------------------------------------------
When [LCD Confirm.] is set to [Hold], the displayed image can also be enlarged
(GP.55) or deleted (GP.56).
Changing Image Confirmation Time
(LCD Confirm.)
Available Settings
Off (The image is not displayed for confirmation.)
0.5Sec. *Default setting
1 Sec.
2 Sec.
3 Sec.
Hold (The image remains displayed until the next time you half-press the shutter release
button.)