Ricoh R10 User Manual

3
Observe the following precautions to ensure safe use of this unit.
 Do not touch the internal components of the equipment if they become exposed as a
result of being dropped or damaged. The high-voltage circuitry in the equipment could
lead to an electric shock. Remove the battery as soon as possible, being careful to
avoid electric shocks or burns. Take the equipment to your nearest dealer or service
center if it is damaged.
 Do not use the equipment in wet areas as this could result in fire or electric shock.
 Do not use the equipment near flammable gases, gasoline, benzene, thinner or similar
substances to avoid the risk of explosion, fire or burns.
 Do not use the equipment in locations where usage is restricted or prohibited as this
may lead to disasters or accidents.
 Wipe off any dust that accumulates on the electrical plug as this may lead to fire.
 Use only the specified AC adapter in household electrical outlets. Other adapters pose
the risk of fire, electric shock or injury.
 To avoid the risk of fire, electric shock or injury, do not use the battery charger or AC
adapter with commercially available electronic transformers when traveling abroad.
 Contact with fluid leaking from a battery can lead to burns. If part of your body comes
in contact with a damaged battery, rinse the area with water immediately. (Do not use
soap.)
If a battery starts to leak, remove it immediately from the equipment and wipe the
battery chamber thoroughly before replacing it with a new battery.
 Plug the power cords securely into the electrical outlets. Loose cords pose a fire
hazard.
 Do not allow the camera to get wet. In addition, do not operate it with wet hands. Both
pose the risk of electric shock.
 Do not fire the flash at drivers of vehicles, as this may cause the driver to lose control
and result in a traffic accident.
Safety Precautions for
Accessories
When using optional products, carefully read the instructions provided with the
product before using that product.
Caution

Ricoh R10 Specifications

General

Megapixel	10 MP
Sensor type	CCD
Image stabilizer	Yes
Image sensor size	1/2.3 \
Maximum image resolution	3648 x 2736 pixels
Optical zoom	7.1 x
Combined zoom	34.1 x
Focal length range	4.95 - 35.4 mm
Digital SLR	No
Minimum RAM	256 MB
Minimum processor	Pentium III 500MHz
Camera shutter speed	1 - 1/2000 s
Minimum storage drive space	160 MB
Minimum system requirements	CD-ROM
Compatible operating systems	Windows 2000/Me/XP/Vista
Focal length (35mm film equivalent)	28 - 200 mm
Auto focusing (AF) modes	multi point auto focus, spot auto focus
Macro focusing range (tele)	0.25 - ∞ m
Macro focusing range (wide)	0.01 - ∞ m
Auto Mode focusing range (tele)	1 - ∞ m
Auto Mode focusing range (wide)	0.3 - ∞ m
Flash modes	auto, Flash off, Red-eye reduction, Slow synchronization
Flash range (tele)	0.25 - 2 m
Flash range (wide)	0.2 - 3 m
Video formats supported	AVI
Display diagonal	3 \
Display resolution (numeric)	460000 pixels
USB version	2.0
Scene modes	Close-up (macro), Documents, Night landscape, Night portrait, Portrait, Landscape (scenery)
Image editing	resizing, trimming
White balance	auto, Cloudy, Fluorescent, Incandescent, manual
Camera playback	movie, single image
Self-timer delay	2, 2+10, 10 s
Product color	Brown
Battery life (CIPA standard)	300 shots
Number of batteries supported	1
Operating temperature (T-T)	0 - 40 °C
Compatible memory cards	sd
Light metering	Centre-weighted, Spot
Light exposure modes	Auto

Weight and Dimensions

Depth	26.1 mm
Width	102 mm
Height	58.3 mm
Weight	168 g