Loading paper and documents
13
2
Note
• Put the paper into the manual feed slot
with the side to be printed face up.
• Make sure that the paper or print media
(see Acceptable paper and other print
media on page 16.) is straight and in the
correct position on the manual feed slot. If
it is not, the paper or the transparency
may not be fed correctly, resulting in a
skewed printout or a paper jam.
• Do not put more than one sheet of paper
in the manual feed slot at any one time, as
it may cause a jam.
• If you put any print media in the manual
feed slot before the machine is in the
Ready state, the print media may be
ejected without being printed on.
• To easily remove a small printout from the
output tray, lift up the scanner cover by
using both hands as shown in the
illustration.
• You can still use the machine while the
scanner cover is up. To close the scanner
cover, push it down with both hands.
To Next Page
Loading...
