Ricoh SP 1200SF - Restricting dialling; Receiving a Fax; Receive modes; Choosing the receive mode

Security features
29
4
Changing your setting lock password4
a Press Menu, 1, 8, 2.
b Press a or b to choose Set Password.
Press OK.
c Enter your four-digit password.
Press OK.
d Enter a four-digit number for the new
password.
Press OK.
e Re-enter your new password when the
LCD shows Verify:.
Press OK.
f Press Stop/Exit.
Turning setting lock on/off 4
If you enter the wrong password when
following the instructions below, the LCD will
show Wrong Password. Re-enter the
correct password.
Turning setting lock on 4
a Press Menu, 1, 8, 2.
b Press a or b to choose On.
Press OK.
c Enter your four-digit password.
Press OK.
d Press Stop/Exit.
Turning setting lock off 4
a Press Menu, 1, 8, 2.
b Enter your four-digit password.
Press OK twice.
c Press Stop/Exit.
Restricting dialling 4
This feature is to prevent users from sending
a fax or call to a wrong number by
mistake.You can set the machine to restrict
dialling by using the dial pad, One Touch and
Speed Dial.
If you choose Off, the machine does not
restrict the dialling method.
If you choose Enter # twice, the machine
will prompt you to re-enter the number, and
then if you re-enter the same number
correctly, the machine will start dialling. If you
re-enter the wrong number, the LCD will
show an error message.
If you choose On, the machine will restrict all
fax sending and outbound calls for that
dialling method.
Dial pad restriction 4
a Press Menu, 2, 6, 1.
b Press a or b to choose Off,
Enter # twice or On.
Press OK.
c Press Stop/Exit.
One Touch restriction 4
a Press Menu, 2, 6, 2.
b Press a or b to choose Off,
Enter # twice or On.
Press OK.
c Press Stop/Exit.