2-20
Confidential
Jam Tray 1 Remove the
jammed paper from
Tray 1.
When printing from the paper
tray, the registration front sensor
does not detect paper pass
within the specified time after
the T1 paper feed sensor
detected paper pass.
7302 2-34
Machine Error
F9
-
The spec code was not entered
correctly.
F900 2-39
Manual Feed Load #S paper.
There is no paper set in the
manual feed slot on the manual
feed slot printing.
8C00 2-36
Media
Mismatch
Reload correct
paper in Tray 1,
then press Go.
When printing from the paper
tray, paper type setting in the
machine does not match the
setting in the driver.
9202 2-37
No Drum Unit Open the Front
Cover, then install
the Drum Unit.
Detected that the drum unit was
not set by detecting the grid
terminal current.
6200 2-31
No Paper Reload paper in
Tray.
Detected that there was no
paper set in all trays when
TrayAuto was selected for
printing.
9309 2-38
No Paper T1 Reload paper in
Tray 1.
When paper was fed from the
paper tray, the T1 paper feed
sensor detected that no paper
was in the paper tray.
9302 2-37
-
When paper was fed from the
paper tray, the engine status
detected that no paper was in
the paper tray.
--- 4.2.1
No Toner Open the Front
Cover, then install
Toner Cartridge.
The new toner sensor detected
that no toner cartridge was set.
6101 2-30
Out of Memory Press Go for 2
seconds.
The memory is insufficient to
expand the data of PC-Print.
C700 2-39
Paper Low T1 -
Detected that the paper is
running out when the paper
feed motor drive and T1 paper
feed sensor turned ON.
--- 4.11.3
Print Data Full Print Data is full.
Press Cancel and
delete the
previously stored
data.
The memory used to store
secure print data exceeded the
memory size for secure print
data.
C800 2-39
Print Unable
01
Turn the power off
and then back on
again.
ASIC error or motor driver error
occurred.
0102 2-24
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
