2-21
Confidential
Print Unable
02
Turn the power off
and then back on
again.
Cannot detect the synchronized
signal of the paper feed motor.
The speed of the paper feed
motor does not stabilize within
the specified time.
0201 2-24
Print Unable
03
Turn the power off
and then back on
again.
Cannot detect the lock signal of
the polygon motor for the laser
unit. (second time)
0300 2-24
Print Unable
04
Turn the power off
and then back on
again.
BD sensor failure (second time)
0401 2-25
Print Unable
05
Turn the power off
and then back on
again.
Detected the fuser unit
temperature error.
0501 2-26
0502 2-26
0503 2-26
0504 2-26
0505 2-26
0506 2-26
0508 2-26
050A 2-26
050B 2-26
050C 2-26
Print Unable
09
Turn the power off
and then back on
again.
Detected irregular power supply
for more than 100 times.
0900 2-27
Print Unable
0A
Turn the power off
and then back on
again.
Detected a fan failure.
0A02 2-27
Print Unable
0B
Turn the power off
and then back on
again.
An error occurred in the high-
voltage power supply PCB
ASSY while operating.
0B01 2-28
An error occurred in the high-
voltage power supply PCB
ASSY when the machine was in
the ready state.
0B02 2-28
Print Unable
3A
Turn the power off
and then back on
again.
A communication error occurred
between the controller and
engine in main PCB.
3A00 2-28
Print Unable
E0
Turn the power off
and then back on
again.
An error occurred in the ROM
check sum.
E000 2-39
Print Unable
E1
Turn the power off
and then back on
again.
Program error
E100 2-39
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
