2-23
Confidential
Size Error DX Press Go for 2
seconds. Specify
the correct paper
and load the same
size paper as the
Printer driver
setting.
For 2-sided printing, paper size
setting of the printer driver that
was not supported by 2-sided
printing was selected.
9701 2-38
Specify the correct
paper.
The registration rear sensor
detected that the paper fed was
smaller or larger than the
specified size in duplex printing
mode.
8A01 2-36
Size mismatch Load #S paper in #T
and press Go.
The size of paper loaded in the
paper tray and the one specified
from the driver are not same
when paper is fed from the
paper tray.
9002 2-36
Toner Ended Open the Front
Cover, replace
Toner Cartridge.
Toner cartridge has reached the
upper limit in the continuous
printing mode.
4E01 2-29
Toner Low -
Dot counter of the toner
cartridge or develop roller
counter reaches the upper limit
soon.
4B01 2-29
2-sided
Disabled
Close the Back
Cover of the
machine.
The back cover sensor detected
the open state when 2-sided
printing is started (before the
registration of printing in the
engine).
8903 2-35
The back cover sensor detected
the open state during 2-sided
printing (after the registration of
printing in the engine).
8904 2-35
Error message
Description
Error
codes
Refer
to:
Initial display Scroll
To Next Page
Loading...
